Home/News/Wedge Wire Screens or Perforated Plate: Choosing the Opening | ERQI WIRE

Wedge Wire Screens or Perforated Plate: Choosing the Opening | ERQI WIRE

Perforated plate is cheaper, stronger in the flat and available in any workshop; wedge wire has three times the open area and clears itself. The decision usually turns on open area, blinding and where the wear lands.

Perforated plate and wedge wire are the two heavy-duty screening surfaces, and buyers compare them on price first — which is the wrong first question. Plate is cheaper per square metre in almost every case. The comparison that decides the job is open area per unit of strength, and how each surface behaves once solids start arriving.

The open area arithmetic

A perforated plate is limited by its own thickness: hole diameter should be at least the plate thickness, or the punching distorts the sheet, so a 3 mm plate cannot carry 1 mm holes economically, and even at 3 mm holes the open area lands around 30–40 percent at best. A wedge wire panel reaches 30–50 percent open area with a 0.5 mm slot, because the slot is formed between wires rather than cut through solid metal. On fine screening — which is most of the volume in mineral, coal and chemical duty — that gap is the difference between a surface that passes the flow and one that backs it up.

Hole versus slot, once solids arrive

A punched hole is a cylinder through the plate: a near-size particle enters, jams, and stays — and because the hole is round, the wedging force is symmetrical and self-tightening. A wedge slot widens inward, so a particle that clears the face falls through and one that does not is left sitting on the surface where motion or spray removes it. This is the same geometry argument that decides wedge wire against woven mesh, and it applies against plate in exactly the same way, at coarser sizes.

Where plate is genuinely better

Honest answer: plenty of places. Plate is a structural member — it carries load in bending, needs no support frame, and can be bolted straight into a chute or hopper. It survives impact from coarse, heavy rock that would deform a wire surface. It can be cut, drilled and welded in any workshop, which matters when a plant needs a patch panel by tomorrow. And at coarse apertures above roughly 10 mm, blinding is not the problem, so the self-clearing geometry buys nothing and the cheaper surface wins.

Where wedge wire takes over

  • Fine slots. Below about 10 mm, and especially below 3 mm, plate's open area collapses while wedge wire holds its percentage.
  • Blinding duty. Sticky, flaky or near-size feed that cakes on a flat plate falls through a V-slot.
  • Wash and backwash. A wedge surface is cleaned in place; plate with jammed holes has to be physically cleared.
  • Wear at the opening. Plate wears its hole edges round, which slowly changes the cut and lets oversize through; a work-hardened V-wire holds its edge.

The cost question, per season

A wedge wire panel costs several times a plate panel up front. On a duty running continuously with fine slots, the plate versions are replaced repeatedly — each replacement is a shutdown, a crew and a re-set of the deck — and the per-season cost inverts. On a low-hour, coarse-aperture duty, it never does. The same reasoning, applied to the wire section itself, is in the specification guide.

Practical middle ground

Many plants use both: plate for the structural frame, wear plates at the feed impact zone, and wedge wire panels for the screening area itself. That is how we usually quote a retrofit — the wedge wire panels drop into the existing plate frame, and the frame stays. Send the deck drawing and the duty, and the answer will say plainly which surface each part of the deck should be — including the parts where plate is the right call.

More from ERQI

Ready to start your project?

Send us your drawing or sample — we reply within 24 hours on working days.

Request a Quote