Home/Products/Wedge Wire/Wedge Wire Nozzle Strainers
Wedge Wire Nozzle Strainers
Threaded wedge wire nozzles for water treatment internals: fine slots that keep media in the vessel, machined stems that screw into lateral pipes, one alloy end to end. Small parts, specified properly.
Wedge Wire Nozzle Strainers
Threaded wedge wire nozzles for water treatment internals: fine slots that keep media in the vessel, machined stems that screw into lateral pipes, one alloy end to end. Small parts, specified properly.
| Material | 304 / 316L / 2205 duplex; stem and head one alloy |
|---|---|
| Size range | Threaded stems 1/2 inch to 1 inch BSP or NPT; slot 0.15-1.0 mm; lengths 100-500 mm; wedge wire heads with threaded or bayonet caps; batch quantities to thousands |
| Typical application | Sand filter underdrains, ion exchange vessel internals, activated carbon columns, water treatment nozzle and lateral systems, media retention in pressure vessels |
| Cross-section | Square — also drawn to your drawing |
| Surface | Bright drawn, as required |
| Packing | Coil, spool or straight length |
Nozzles are the small end of the wedge wire range — hundreds of them in one vessel, each doing the same two jobs: hold the media in, spread the water evenly. Because they screw into lateral pipes and branch headers, the threaded stem has to be exact, and because they sit under tonnes of media and backwash flow, the slot has to stay exact for years, not shifts.
The nozzle and lateral system
A vessel's underdrain is a system: header, laterals, nozzles. We supply the laterals as wrapped tubes on the screen laterals page and the nozzles to the same slot specification, so the whole internal holds one uniform opening instead of a mix of slot sizes that channels the backwash to whichever nozzle is widest. Uniformity is the quiet difference between a vessel that backwashes evenly and one that develops dead zones.
Sized to the media
The slot follows the media, not the other way round: a sand bed of 0.5–1.5 mm grain wants roughly a 0.15–0.3 mm slot so the finest fraction stays put from the first backwash; ion exchange resin and coarser media allow wider slots and better open area. If your media specification is on hand, the slot comes straight from it — send the grade and we will quote the nozzle against it.
Specifications
| Stem | 1/2", 3/4" or 1" BSP or NPT, machined from bar |
|---|---|
| Slot | 0.15–1.0 mm at the head face |
| Length | 100–500 mm overall, head form to suit your lateral |
| Caps | Threaded or bayonet, removable for media change-out |
| Materials | 304 standard; 316L / 2205 for saline or brine duty |
Nozzles run in batches, so tooling and per-piece price are quoted separately — standard thread and slot off existing tooling price by the piece; a special slot or head form is a die decision first. Send the thread, slot and vessel quantity and the quotation will show both.
Related products
Ready to start your project?
Send us your drawing or sample — we reply within 24 hours on working days.